Board densa, thread reali, navigazione veloce

NSFW Thread

# Unmoderated NSFW Thread I got permission from Niccolo to host this NSFW thread on the forum. Post your best photos here! All photos, vidoes, gifs, and texts welcome.

Greenhouse rack notes

# Thread title Use `plxdoc` to write the post. :::step 1 | Explain the context Mention board, widget and pin mapping. :::

Greenhouse rack notes

# Thread title Use `plxdoc` to write the post. :::step 1 | Explain the context Mention board, widget and pin mapping. :::

Greenhouse rack: dashboard + firmware + irrigation scenes

## My greenhouse automation rack Been running this for 3 months now. Full ESP32-S3 based rack with: - DHT22 for temperature/humidity per zone - Soil moisture sensors (capacitive,

RP2040 PicoW support — anyone tested?

Has anyone tried the Raspberry Pi Pico W with the Plynx firmware? The MicroPython port should work but I am getting auth failures on the TCP handshake. Pico W connects to WiFi fine

Weather station on a balcony: 6-month review

Running a BME280 + UV sensor on my balcony ESP32 for 6 months. Dashboard shows 30-day trends, min/max per day, alerts when temperature drops below 5C. Power: solar + 18650 with dee

Feature: webhook triggers on virtual pin change

Request outbound webhooks from dashboard. Use case: call a webhook URL when V3 exceeds threshold to trigger Home Assistant automations without polling. Would unlock native HA integ

ESP32 keeps disconnecting after 30min

My ESP32 reconnects fine on boot but drops after 30 minutes. WiFi stays connected but Plynx connection dies. Using BLYNK_HEARTBEAT 30 but still drops. Is there a session timeout se

PlynxConnector v2: pin batching reduces WiFi wakeups 70%

Pushed v2.1.0 of PlynxConnector. Key change: pin value batching. Buffer writes for 50ms then flush as single batch frame. On 12 virtual pins at 10Hz: wakeups dropped from 120/s to

ESP32 keeps disconnecting after ~30min — Auth timeout?

## Problem My ESP32 reconnects to Plynx fine on boot, but after about 30 minutes it drops and never reconnects automatically. The WiFi is still connected (I can ping the board), i

PlynxConnector v2: new pin batching reduces WiFi wakeups by 70%

## PlynxConnector firmware update Just pushed v2.1.0 of PlynxConnector for ESP32. Key change: **pin value batching**. Instead of one TCP frame per `Blynk.virtualWrite()` call, we

Feature request: webhook triggers on virtual pin change

## Request: Outbound webhooks from dashboard **Use case:** I want Plynx to call a webhook URL whenever V3 goes above a threshold, so I can trigger a Home Assistant automation with